PROCAP A7
Spray etching gel for aluminum alloys. PROCAP A7 spray gel replaces favorably the etching bath of non-submerged equipment (large surfaces, multi-material, etc...).
Usage:
Before using PROCAP A7 , read the safety data sheet and observe health and safety rules.
Before using PROCAP A7, read the safety data sheet and observe health and safety rules.
Before use, shake the container to obtain a uniform consistency. The gel can be mixed with a colorant, which will allow the product to be evenly applied to the surface and will reduce nitrogen gases. The gel is applied to a dry surface, with a hand or pneumatic pump. During etching, the gel should not be allowed to dry out by sunlight or other heat sources. After etching, the surface should be thoroughly rinsed with a large amount of cold water at a pressure of about 150 bar until the pH is neutral.
PROCAP A7 provides active and uniform etching of aluminum alloys. Capacity of 1kg = 3-5 m2